920-451 Exam

- Covers the entire recommended syllabus
- Comprehensive questions and answers about 920-451 exam
- Verified Answers Researched by Industry Experts and almost 100% correct
- 920-451 exam questions updated on regular basis
- Same type as the certification exams, 920-451 exam preparation is in multiple-choice questions (MCQs)
- Tested by multiple times before publishing
- Try free 920-451 exam demo before you decide to buy it in Hiexam
- Technical support through Live Chat or Email

　
　
Exam : Nortel 920-451
Title : NCDE Callpilot 2.x/3.0 Unified Messaging
Version : Demo


1. A customer is installing a Communication Server (CS) 1000M-SG Rls. 4.0 at their Main Office (MO). They have a 10-member network using the corporate WAN and a Primary Gatekeeper. They want to use an Alternate Gatekeeper for redundancy. When are the Alternate Gatekeepers programmed? (Choose two.)
A. during software installation and initial setup of the Signaling Server
B. in Overlay LD 17 (Configuration) under the ADAN as an ELAN IP address
C. in Overlay LD 117 (Configuration2) as an Embedded LAN (ELAN) IP address
D. in Element Manager under the Signaling Server setting after the software has been installed
Answer: AD

2. A customer has just installed a Communication Server (CS) 1000M system. The CS 1000M is networked via the corporate WAN with several offices around the country. BARS is configured correctly for all telephones to use this route and the Virtual Trunks show IDLE. Traffic studies have shown that the majority of calls to remote locations are going out via the PSTN route instead of the virtual route. What in the configuration could cause this situation?
A. CODEC is not assigned to the Virtual Trunk Route
B. Bandwidth is incorrectly defined in the Zone Basic Property
C. CODEC not defined for the zone in the Zone Basic Property
D. Bandwidth is not defined for the Virtual Trunk Route and member trunks
Answer: B

3. A customer has a network that contains several Communication Server (CS) 1000 Rls 4.0 systems. They are networked together via Virtual Trunks. The customer has limited bandwidth on the WAN links between sites and has an Optimized WAN link to carry Voice calls that use G.729A. Which configuration setup will ensure that G.729 is always used on a virtual trunk call between sites?
A. No extra configuration is needed. Virtual Trunk calls always use G.729A CODEC.
B. ? configure the virtual route to be in same zone as voice gateway channels and IP sets ? verify that the customer has G.729A as part of CODEC profile ? verify all zones at the site are configured with best quality for intrazone calls and best bandwidth for interzone calls
C. ? virtual route is configured to be in different zone than the voice gateway channels and IP sets ? verify the customer has G.729A as part of CODEC profile ? ensure all zones at the site are configured with best quality for intrazone calls and best quality for interzone calls
D. ? the virtual route is configured to be in a different zone than voice gateway channels and IP Sets for each system ? verify the customer has G.729A as part of CODEC profile ? ensure all zones at the site are configured with best quality for intrazone calls and best bandwidth for interzone calls
Answer: D

4. A customer has installed two Communication Server (CS) 1000M Rls. 4.0 systems networked over the corporate WAN. Some of the system management functions of the CS 1000M can be performed by the Command Line Interface (CLI) as well as Element Manager. Which is a false statement regarding the use of Element Manager (EM) over the CLI?
A. EM provides for drop down menus for prompt choices.
B. EM provides full text descriptions of parameters and acronyms.
C. EM allows the programmer to use the LD commands as well as using menus.
D. EM increases speed and efficiency be organizing parameters to logical groups.
Answer: C

5. A customer has a Communication Server (CS) 1000 Rls. 4.0 that they want to network with two other sites using the corporate WAN. Why must zones be configured with Element Manager before the Virtual Routes? (Choose two.)
A. Zones determine NCOS privileges on a given trunk.
B. Zones govern trunk groupings for TGAR assignment.
C. Zones help determine Best Bandwidth CODEC per virtual trunk call.
D. Zones manipulate CODEC selections and assigns bandwidth to a route.
E. Zones provide call blocking based on Bandwidth defined for inter- and intra-zone calls.
Answer: CE

http://www.Hiexam.com The safer.easier way to get Other Nortel Certification Certification.