640-863 Exam

- Covers the entire recommended syllabus
- Comprehensive questions and answers about 640-863 exam
- Verified Answers Researched by Industry Experts and almost 100% correct
- 640-863 exam questions updated on regular basis
- Same type as the certification exams, 640-863 exam preparation is in multiple-choice questions (MCQs)
- Tested by multiple times before publishing
- Try free 640-863 exam demo before you decide to buy it in Hiexam
- Technical support through Live Chat or Email

　
　
Exam : Cisco 640-863
Title : Designing for Cisco Internetwork Solutions


1. Which statement identifies a benefit obtained when using a top-down network design plan?
A. allows quick responses to design requests
B. facilitates design based on previous experience
C. incorporates customer organizational requirements
D. is less time-consuming than using a bottom-up approach
E. provides a more detailed picture of the desired network
Answer: C

2. Which of these is the equation used to derive a 64 Kbps bit rate?
A. 2 x 8 kHz x 4-bit code words
B. 8 kHz x 8-bit code words
C. 2 x 4-bit code words x 8 kHz
D. 2 x 4 kHz x 8-bit code words
Answer: D

3. Which two of these are functions of an access point in a Split MAC Network Architecture?(Choose two.)
A. EAP Authentication
B. MAC layer encryption or decryption
C. 802.1Q encapsulation
D. Process probe response
Answer: BD

4. Which two of the following statements represent a preferred wireless LWAPP implementation?(Choose two.)
A. verify open ports for:
Layer 2 LWAPP on ethertype OxABAB
Layer 3 LWAPP on TCP 12222 and TCP 12223
B. verify open ports for:
Layer 2 LWAPP on ethertype OxBBBB
Layer 3 LWAPP on UDP 12222 and UDP 12223
C. verify open ports for:
Layer 2 LWAPP on ethertype OxBABA
Layer 3 LWAPP on UDP 12222 and TCP 12223
D. use of Layer 3 LWAPP is preferred over Layer 2 LWAPP
E. use of Layer 2 LWAPP is preferred over Layer 3 LWAPP
Answer: BD

5. Lightweight access points are being deployed in remote locations where others are already operational.
The new access points are in a separate IP subnet from the wireless controller. OTAP has not been enabled at any locations.
Which two methods can the AP use to locate a wireless controller? (Choose two.)
A. local subnet broadcast
B. NV-RAM IP address
C. DHCP
D. primary, secondary, tertiary
E. DNS
F. master
Answer: CE

http://www.Hiexam.com The safer.easier way to get CCDA Certification.