640-460 Exam

- Covers the entire recommended syllabus
- Comprehensive questions and answers about 640-460 exam
- Verified Answers Researched by Industry Experts and almost 100% correct
- 640-460 exam questions updated on regular basis
- Same type as the certification exams, 640-460 exam preparation is in multiple-choice questions (MCQs)
- Tested by multiple times before publishing
- Try free 640-460 exam demo before you decide to buy it in Hiexam
- Technical support through Live Chat or Email

　
　
Exam : Cisco 640-460
Title : IIUC Implementing Cisco IOS Unified Communications (IIUC)


1. Which of the following is selected first for an incoming dial peer?
A. Answer-address
B. incoming called-number
C. destination-pattern
D. pots port
Answer: B

2. What is the default VTP mode on Cisco switches?
A. Master
B. Client
C. Backup
D. Server
Answer: D

3. Power over Ethernet (PoE) is the ability for the LAN switching infrastructure to provide power over a copper Ethernet cable to an endpoint (Powered Device). This capability, once referred to as "inline power", was originally developed and first delivered by Cisco in 2000 to support the emerging IP Telephony deployments. IP Telephones, like desktop PBX phones, need power for their operation and Power over Ethernet enables scalable and manageable power delivery and simplifies deployments of IP Telephony. As Wireless networking emerged, Power over Ethernet was also used to power these devices to allow for deployments in locations where local power access did not exist. While IP telephones and wireless access points are the most intuitive uses for PoE, the advent of 802.3af standardization of PoE opens the door to a new generation of networked-attached devices such as video cameras, point-of-sale devices, security access control (card scanners), building automation and industrial automation just to name a few. When a Cisco switch supply PoE to an IP phone?
A. whenever switch and IP phone are Cisco products.
B. when Cisco switch supports prestandard PoE and the IP phone supports 802.3af.
C. when Cisco switch and IP phone both support a common PoE method.
D. Only when both the switch and IP phone use 802.3af PoE.
Answer: C

4. You are CCNA VOICE associate in TestInside.com. You need configure a voice port that will allow the gateway to terminate 23 or 30 circuits from the PSTN. Which type of voice port you will configure?
A. BRI
B. FXS
C. PRI T1/E1
D. E&M
Answer: C

5. Which Cisco Unified Communications layer is the call processing layer?
A. Layer A including video,communications client, software-based phones, IP Phone
B. Layer B including Voice mail,Presence,Contact Center
C. Layer C including Cisco Unified Communications manger,Directory Server.
D. Layer D including Gateway, Router, Switch.
Answer: C

http://www.Hiexam.com The safer.easier way to get Others Certification.